Hi Everyone - Having a bit of a headache here, and I hope somebody can help.
I have set up Multipoint 2012. Installed all Windows Updates and made sure that the Wyse E02 drivers are installed too. My set up is as follows:
HP Proliant M310e Gen8 V2 server (empty with fresh instal of WMS2012)
Ethernet out to Switch
2 Wyse E02's leading off switch by Ethernet.
Screens, Keyboard/Mouse attached to respective E02.
The issue I have is that singularly both Wyse E02's will work. That is to say that when one is switched off and not speaking to the switch/WMS, the other works perfectly well and is stable.
However, when the second Wyse E02 (whichever is 1st/2nd is matterless) the system lets one speak to WMS for about a minute and a half while the other resets. Then the first will reset while the 2nd talks to WMS, and so the loop goes on.
I'm sure I'm just missing some little tick-box or small setting that's easily fixable, but need some help....before I tear the rest of my hair out (there's not much left)
Kind regards,
Steve